Username Password
HOME EN |   JP |   TW

Banner




- Forgot your password?
- Forgot your username?


Your Cart is currently empty.

My status

Live Chat Support

Banner

Connect with us:
   

Exchange Rate Ref.:
US$1 = RMB$6.5
US$1 = HK$7.8

Welcome, Guest
Please Login in left hand box or Register.    Lost Password?

How to bridge the TA-10
(1 viewing) (1) Guest
TA-10 Class-T Amp
Go to bottomPage: 12
TOPIC: How to bridge the TA-10
*
#98
How to bridge the TA-10 13 Years, 10 Months ago  
1. Is it possible to bridge the amp ? If it is possible, what would be its power rating as a monobloc ?
2. Is it easy to change components inside ?
Last Edit: 2010/05/11 06:13 By admin.
The administrator has disabled public write access.
 
#254
Re:How to bridge the TA-10 13 Years, 10 Months ago  
1. Yes, TA-10 can be bridged. The power is about 50-70% increased subject to the impedance of your speakers.
2. Yes, most components insides are through-hole and reserve some soldering holes for different size components.
The administrator has disabled public write access.
 
#255
Re:How to bridge the TA-10 13 Years, 10 Months ago  
How do you bridge the Trends TA-10 amp?
The administrator has disabled public write access.
 
#256
Re:How to bridge the TA-10 13 Years, 10 Months ago  
Simply input the signal to both LEFT and RIGHT inputs. Then, connect the outputs MONO +ve to the LEFT +ve and the MONO -ve to the RIGHT -ve.
The administrator has disabled public write access.
 
#257
Re:How to bridge the TA-10 13 Years, 10 Months ago  
can you pleace explain that agin? I donĀ“t quite understand
The administrator has disabled public write access.
 
#258
Re:How to bridge the TA-10 13 Years, 10 Months ago  
WebMaster,

The procedure you described is not what I would call a "true bridging" but more like running the output stages in parallel. However it could probably work fine.

A true bridging would be to use a balanced output from the source and apply the + to the one input and - to the other input. Speakers should then be connected to the two plus terminals with no connection to the negative terminals. Output power should then (depending on psu) be 4 times rated output. Would this procedure work? I know that it depends on the general design if possible or not.

Best regards,
Karsten
The administrator has disabled public write access.
 
Go to topPage: 12

Protected by R Antispam